Thermal Relief Valves

The Model "TRV" thermal relief valve is typically installed into a pressure washer system where a maximum specific water temperature is desired.

The Model "TRV" pressure relief valve remains sealed at low temperature levels, but as the temperature rises, the valve begins to open. The valve discharges water from the system to atmosphere, and thus maintains a desired maximum temperature. Available in 1/4", 3/8" and 3/4" NPT. Also available with a directional plastic cap.

Easy Start Valve

The Model "ESV" easy start valve is typically installed into a pressure washer system where the valve remains open until a specific pressure is reached at which time the valve closes off.

The valve is installed into a system so it will bypass water from the high pressure side of the pump back to the inlet by means of an external hose. Connection size is 3/8" NPT inlet x 1/4" Hose Barb outlet.

Garden Hose Adapters

Garden Hose Swivel Adapters feature a brass garden hose swivel. Many different outlet configurations are offered, including 1/2" FNPT, 3/8"MNPT, 1/2" BSP, and 3/8" hose barb.

Injectors

The Model "CJ" chemical injector valve is typically installed into a pressure washer system for the purpose of drawing chemicals into the flow of water while running in low pressure mode.

The valve is offered in both adjustable and non-adjustable versions, with the adjustable version allowing for manual control of the chemical injection rate. Three orifice sizes are offered to meet your flow requirements. Connection sizes include 3/8" MNPT, 3/8" FNPT, and M22.

Inlet Strainer

The Inlet Strainer is located at the inlet of a pressure washer. The Inlet Strainer contains a removable screen which stops any contaminates from entering the pump system. The screen is designed so it may be removed and cleaned.

The Strainer also includes a fitting at 90° to the main flow of the valve used to bypass water back to the inlet of the system. Connection is 1/2" FNPT x Garden hose, with a 1/4" Hose barb.

Pressure Relief Valves

The Model "PWR" pressure washer relief valve is typically installed into a pressure washer system where a maximum specific water pressure is desired.

The Model "PWR" pressure relief valve can be set to open at various set pressures, depending upon the adjusting spring being used. The valve will begin to open once the system pressure matches the valve set pressure, and flow will increase as the pressure rises above the set pressure. The valve will shut off at the same pressure at which it opened. The valve discharges water from the system to atmosphere, and thus maintains a desired maximum pressure.